Renco Controls, Inc., Benton, Arkansas Series REN300

ERGONOMICALLY DESIGNED PNEUMATIC
TWO-HAND NO-TIE-DOWN CONTROLS

Pneumatic Models                       Electric Models
REN23 | REN28 | REN300 | REN44 | REN45 | REN46

CLAMP CIRCUIT REN-CC-1004A

THE CLAMP CIRCUIT IS USED WITH A 2-HAND CONTROL, END OF STROKE SENSOR (-EOSS) TO LATCH THE CIRCUIT ON, A RELEASE BUTTON OR AN OPTIONAL TIMER TO RELEASE. ALL ARE PNEUMATIC. THIS ALLOWS AN AIR CYLINDER TO REMAIN CLAMPED AFTER THE OPERATOR REMOVES HANDS FROM THE 2-HAND CONTROL. THE WORK PIECE THICKNESS MAY VARY AS THE END OF STROKE SENSOR DETECTS WHEN THE CYLINDER STOPS.

TYPICAL OPERATION: OPERATOR PRESSES THE 2 GREEN BUTTONS ON THE 2-HAND CONTROL, THE CYLINDER ADVANCES AND CLAMPS ON TO THE WORK PIECE, A SIGNAL IS SENT TO THE CLAMP CIRCUIT TO LATCH ON. HANDS MAY BE REMOVED FROM THE 2-HAND CONTROL. THE RELEASE BUTTON OR AN OPTIONAL TIMER IS USED TO RELEASE.




*OPTIONS AVAILABLE ON THE REN-CC-1004A.*

-TMR	A 1-20 SECOND ADJUSTABLE TIMER TO UNCLAMP AFTER THE ADJUSTED TIME IS REACHED.
-TMR300	A 5-300 SECOND ADJUSTABLE PNEUMATIC MECHANICAL TIMER IS USED TO UNCLAMP AFTER THE ADJUSTED TIME IS REACHED.
-4W	A 1.1CV 4-WAY VALVE IS INTEGRATED INTO THE CLAMP CIRCUIT.
-REN-SP14	A SEPARATE 1.1CV, 1.4"NPT 4-WAY VALVE IS SHIPPED WITH THE CLAMP CIRCUIT.	N/C
-REN-SP12	A SEPARATE 4.5CV, 1/2"NPT 4-WAY VALVE IS SHIPPED WITH THE CLAMP CIRCUIT.
-EOSS-XX	A SCREW IN THE CYLINDER PORT PNEUMATIC SENSOR IS SHIPPED WITH THE CLAMP CIRCUIT. REPLACE THE XX WITH 1/8, 1/4, 3/8, OR 1/2 TO DESIGNATE THE CYLINDER PORT SIZE IN NPT.
-REN-LMV	A COMPACT LIMIT VALVE THAT CAN BE USED AS THE END OF STROKE SENSOR WITH 5/32 PUSH LOCK FITTINGS.
-1/4	THE CLAMP CIRCUIT WILL COME WITH 1/4" PUSH LOCK FITTINGS IN PLACE OF THE STANDARD 5/32 PUSH LOCK FITTINGS. PORTS ON THE CLAMP CIRCUIT ARE 1/8NPT AND FITTINGS MAY BE CHANGED IN THE FIELD.

DIAGRAM

WARNING: ALL RENCO CONTROLS ARE DESIGNED TO OPERATE PNEUMATIC VALVES AND CYLINDERS. THEY ARE NOT TO BE USED WITH FLYWHEEL PRESSES, BRAKE PRESSES OR SIMILAR DEVICES. IT IS THE BUYERS RESPONSIBILITY TO DETERMINE THE USE AND MOUNTING LOCATION OF THIS DEVICE. THIS EQUIPMENT PERFORMS THE FUNCTION OF A TWO HAND NO TIE DOWN CONTROL ONLY, ALL OTHER PRESCRIBED SAFETY DEVICES MUST BE USED WITH THE EQUIPMENT. IT IS THE BUYERS RESPONSIBILITY TO DETERMINE THE PROPER APPLICATION, LOCATION AND USE OF THIS EQUIPMENT